Shipbuilding and shipyards
Gantry and overhead travelling cranes for handling blocks, steel plates and equipment in shipbuilding and shipyards.
In shipyards, loads of very different sizes are handled during plate preparation, block fabrication and outfitting. High-capacity gantry cranes work in open yards and overhead travelling cranes in enclosed workshops.
The marine environment increases corrosion; surface protection and electrical equipment are selected accordingly. Two-crane operation is planned for turning large blocks.
Recommended cranes and equipment for shipbuilding and shipyards
- Double Girder Gantry Cranes
- Semi-Gantry Cranes
- Double Girder Overhead Travelling Cranes
- Single Girder Overhead Travelling Cranes
Engineering and service
For shipbuilding and shipyards, LIFTKON engineers the crane system according to on-site measurements, the load profile and the intensity of use, and handles manufacturing, installation, commissioning and periodic maintenance from a single source. To receive a quotation, simply share the capacity, span and lifting height.
Lifting requirements in this industry
- Block handlingHigh-capacity gantry crane.
- Marine environmentCorrosion-resistant design.
- Block turningSynchronised two-crane operation.
Products for this industry

Double Girder Gantry Cranes
Heavy lifting for open yards and sites without runways

Double Girder Overhead Travelling Cranes
High-capacity overhead crane for heavy and frequent lifting

Single Girder Overhead Travelling Cranes
Economical overhead crane for low-headroom and narrow-bay buildings

Semi-Gantry Cranes
Semi-gantry crane for heavy loads between building and yard
Share the technical data of your project
Send us capacity, span and operating conditions — our engineering team will prepare the right solution.
