Vinç Teker Bloğu — parça şeması (LIFTKON çizimi, ürün fotoğrafı değildir)

Crane Wheel Block

AISI 1045 crane wheel for long life and quiet running

The crane wheel block is a complete travel element of wheel, axle, bearings and housing that lets cranes and trolleys run on rails. LIFTKON wheel blocks are made from AISI 1045 steel.

A wheel block is a ready-to-install travel element consisting of a wheel, axle, bearings and housing. It is used on crane bridges, crane trolleys, gantry cranes and transfer carts. Its quality directly affects smooth crane travel, rail and wheel wear, and vibration.

LIFTKON wheel blocks

Wheel blocks are made from AISI 1045 steel. They offer noise damping and high bearing performance and are designed to tolerate centre misalignments of up to ±20 mm. They are standard on LIFTKON crane trolleys and travel drive units.

Replacement and spares

Flange wear, rail marks, noise during travel or crabbing indicate that wheel blocks need checking. Wheel blocks can be made to suit your existing cranes. For replacement, submit a service request or request a quote.

Selection and application

The data that drive the selection of a Crane Wheel Block are the crane’s capacity, duty class (FEM/ISO), travel speed and mounting dimensions. The duty class states how many hours the part must withstand a given load cycle and feeds directly into material, heat treatment and section size. Two cranes of the same capacity in different duty classes do not use the same part.

LIFTKON produces this part both for its own cranes and for other makes already in service. A correct match needs the crane make, capacity, serial number if available and the dimensions of the existing part; a photograph of the worn part also helps. A sketch or drawing can be attached to the quotation form.

Advantages

  • AISI 1045 steel
  • ±20 mm misalignment toleranceCompensates wheel centre misalignment.
  • Quiet runningNoise damping and high bearing performance.
  • Ready to installSupplied as a complete block.

Applications

  • Overhead travelling cranes
  • Crane trolleys
  • Gantry cranes and transfer carts

Options

  • Driven or idle block
  • Wheel profile to suit the rail

Frequently asked questions

How do I know a wheel block needs replacing?
Flange wear, rail noise, crabbing during travel or irregular rail marks indicate it should be checked.
Can you make wheel blocks for an old crane?
Yes. Existing dimensions and rail type are measured and a matching block is manufactured.
What information is needed to select the right part?
The crane make, capacity, duty class and the mounting dimensions of the existing part. A serial number and a photograph of the worn part speed up the match.
Does it fit cranes of other makes?
Yes, as long as the dimensions and the duty class match. Compatibility is checked beforehand from a dimensioned sketch or a photograph of the existing part.

Share the technical data of your project

Send us capacity, span and operating conditions — our engineering team will prepare the right solution.