Section and profile manufacturers
Overhead travelling cranes for coil feeding and handling long bundles at section and hollow section manufacturers.

Profile lines start with coil feeding and end with stacking and dispatching long bundles. Long and flexible bundles must be lifted at several points with a lifting beam.
For cranes running along the length of the line, speed determines product flow. If the stockyard is outdoors, a gantry or semi-gantry crane solution is considered.
Recommended cranes and equipment for section and profile manufacturers
- Double Girder Overhead Travelling Cranes
- Single Girder Overhead Travelling Cranes
- Double Girder Gantry Cranes
- Semi-Gantry Cranes
- Lifting Beam
Engineering and service
For section and profile manufacturers, LIFTKON engineers the crane system according to on-site measurements, the load profile and the intensity of use, and handles manufacturing, installation, commissioning and periodic maintenance from a single source. To receive a quotation, simply share the capacity, span and lifting height.
Lifting requirements in this industry
- Coil feedingFast and safe feeding with a C-hook.
- Long bundlesLifting beams that lift at several points.
- Outdoor stockYard utilisation with a gantry crane.
Products for this industry

Double Girder Gantry Cranes
Heavy lifting for open yards and sites without runways

Double Girder Overhead Travelling Cranes
High-capacity overhead crane for heavy and frequent lifting

Single Girder Overhead Travelling Cranes
Economical overhead crane for low-headroom and narrow-bay buildings

Semi-Gantry Cranes
Semi-gantry crane for heavy loads between building and yard

Lifting Beam
Safe crane handling of long and unbalanced loads
Share the technical data of your project
Send us capacity, span and operating conditions — our engineering team will prepare the right solution.
